Difference between revisions of "Palawan EVT to DVT changes"

From Studio Kousagi Wiki
Jump to: navigation, search
(Palawan Rx Board changes)
(Palawan Rx Board changes)
Line 30: Line 30:
  
 
The J- notation is extremely useless.  Use SWx/ADCx notation instead, as it's more useful.
 
The J- notation is extremely useless.  Use SWx/ADCx notation instead, as it's more useful.
 +
 +
 +
==Palawan Tx Board changes==
 +
 +
===ECO7: Decrease white LED resistor R35B to 400 Ohm===
 +
 +
This LED isn't that bright.  Decrease the resistance to around 400 ohm to brighten it up.

Revision as of 08:04, 12 April 2016

Palawan Rx Board changes

ECO1: Swap D11U pins

The diode D11U footprint and schematic pins are swapped. Correct this.


ECO2: Send USB pullups to VPP

The USB pullups on USBDN_RST and USBDP_LED are going to VUSB. They should instead go to VPP, otherwise USB will fail to function.


ECO3: Populate R15U with 1.5k, 10%

Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor.


ECO4: Make debug pins oval

The debug pins on the side should be made oval, for easier soldering


ECO5: Add GND, VPP debug pins

To make life easier, add pins for probing GND and VPP.


ECO6: Change silkscreen for debug pins

The J- notation is extremely useless. Use SWx/ADCx notation instead, as it's more useful.


Palawan Tx Board changes

ECO7: Decrease white LED resistor R35B to 400 Ohm

This LED isn't that bright. Decrease the resistance to around 400 ohm to brighten it up.