Difference between revisions of "Orchard DVT1 to PVT1 BM"

From Studio Kousagi Wiki
Jump to: navigation, search
(Created page with "==ECO1: Save cracked out hippies from accidentally darkwadding themselves== There is a software feature called "ship mode" which is a one-way door on the production doors: on...")
 
(ECO3: Delete BLE)
 
(2 intermediate revisions by the same user not shown)
Line 21: Line 21:
 
| added || SW10B 5x5mm 1.6mm tall PB ||  
 
| added || SW10B 5x5mm 1.6mm tall PB ||  
 
|}
 
|}
 +
 +
UPDATE: decided to cancel this ECO. UI changes should make it hard to darkwad yourself.
 +
 +
==ECO2: Adjust gain on sound==
 +
R11S is adjusted to 47k to make the microphone a little more sensitive.
 +
 +
{| class="wikitable sortable"
 +
|-
 +
! scope="col" | DVT
 +
! scope="col" | PVT
 +
! scope="col" | Notes
 +
|-
 +
| R11S 22k, 1% || R11S 47k, 1%||
 +
|}
 +
 +
==ECO3: Delete BLE==
 +
All BLE components removed.
 +
 +
==ECO4: Flip charge LED==
 +
Put charge status LED on top side so it's visible when case is installed.

Latest revision as of 18:59, 23 June 2015

ECO1: Save cracked out hippies from accidentally darkwadding themselves

There is a software feature called "ship mode" which is a one-way door on the production doors: once you hit it, the system will power off, and will not power on again until you plug it into a USB port.

I could see this being a problem for some people in the deep playa.

Add a bypass switch + diode to jump-start the board into life again if the battery has a high enough voltage (needs to be about 50% capacity or above to jump-start itself).

This feature is a bad idea in Default because it represents a small, but real, safety risk. You're supposed to isolate the battery entirely from the system during "ship mode" to prevent any accidents. The bypass switch gives the remote possibility that a system can power itself on while shipping, leading to a deep discharge of the battery which is a potentially hazardous condition.

But, safety third!

DVT PVT Notes
added D14B BAT54 any SOD-123 BAT54 variant will do
added SW10B 5x5mm 1.6mm tall PB

UPDATE: decided to cancel this ECO. UI changes should make it hard to darkwad yourself.

ECO2: Adjust gain on sound

R11S is adjusted to 47k to make the microphone a little more sensitive.

DVT PVT Notes
R11S 22k, 1% R11S 47k, 1%

ECO3: Delete BLE

All BLE components removed.

ECO4: Flip charge LED

Put charge status LED on top side so it's visible when case is installed.