NeTV Main Page
Welcome to the NeTV developer info page. NeTV is currently available as a development kit for use by developers, reviewers, and other people interested in evaluating the product.
Beta Program: Beta users please see the NeTV beta program page for more info.
This page is intended for technical development use. If you are curious about the consumer facing features of NeTV, please see What is NeTV.
However, as far as developers and hackers are concerned, NeTV is a robust, wifi-enabled embedded linux computer that can connect to HD video sources and sinks. It has very strong potential applications in education, digital signage, smart energy, and low-cost computing.
Developing Software for NeTV
There are two categories of software development for NeTV.
One is firmware development. This includes the kernel, drivers, and application programs. If you are interested in writing C programs on embedded linux, then you should see the Firmware Development section.
There are two methods for developing Firmware on NeTV.
- NeTV AMI Instance. This is intended for developers, OEMs, and professionals requiring a full SDK. Here, you will be walked through the setup and use of a pre-built development environment, complete with cross-compiler, located in the Amazon EC2 cloud. It uses buildbot and bitbake to create a robust development environment that is suitable for immediate production use. This path allows you to build complete ROM images from scratch, and to create packages that can be redistributed easily through on-line firmware updates.
- NeTV local compilation. This is intended for hobbyists and hackers who just need to build a couple programs to get the job done, and do not need a method to deploy their work to a large user base. Here, you can find out how to install gcc on the device and build a quick hello world program.
Please choose a category for application development:
- NeTV local UI -- modifying the UI presented on the screen
- NeTV web services -- port 80 HTTP services that enable webapp, Android and iOS interaction
Various hacks you can do to NeTV. See NeTV tricks
USB Ethernet support
The NeTV is powered by a 5V supply shaped like a Micro-USB connector. Conveniently, the board draws around 300-700 mA of current when running. This is only slightly above USB spec, so you should be able to power it entirely from a USB port on your computer. Note that running the board in this manner can cause HDMI voltage to droop below 4.5V, making them out of spec. Also, some systems will shut off power to a USB port that draws more than 500 mA. This mode is provided as a convenience only.
When booted, the NeTV configures the Micro-USB port to act as an Ethernet gadget. It will configure itself with the IP address 10.0.88.1, and runs a DHCP server that will offer your desktop computer the address 10.0.88.4. You'll need to install a driver in order to get it working.
With the network configured, you will be able to connect to the NeTV board through SSH:
This will work even if the wifi is unconfigured, or if you start fiddling with NetworkManager. This is because the network subsystem completely ignores the usb0 interface.
The NeTV makes extensive use of syslog. It logs both to a local buffer (which you can read by running "logread"), as well as to the USB network on UDP port 6368. To capture these messages, install netcat (which should come with OS X and most Linux distributions) and run:
nc -l -u 6368
To verify logging is working, ssh into your NeTV unit and log a message to syslog:
logger "Hello, world!"
Developing Hardware for NeTV
Hardware source for NeTV's PCB, mechanical design, breakout board, and FPGA can be browsed at http://git.chumby.com.sg/netv_hardware/ (access permissions should now be fixed)
Details on developing for the FPGA, modifying the design, and programming the existing design can be found at NeTV FPGA architecture.