Programming Senoko DVT
- clone and build https://github.com/xobs/stm32flash
- clone and build https://github.com/xobs/senoko-chibios
- go to ./projects/kosagi-senoko and do a make -j4
- hold down reset and program buttons on senoko, and run ./reset.sh to enter STM32 programming mode over UART
- from the kosagi-senoko directory, run:
<path-to>/stm32flash/stm32flash -b 115200 -w build/senoko.hex /dev/ttymxc3
- then run
./reset.sh
To reset the CPU into run mode
- Connect to the serial console of the STM32 gas gauge manager:
screen /dev/ttymxc3 115200
- from the serial console talking to senoko, run these commands in the "ch>" shell:
ch> chg 1000 12600 3000
The above command powers up the gas gauge so you can program it (powered up via the charger, the battery pack is in safe mode)
ch> gg setup 3 3000
The above command sets 3 cells and 3000mAh as the capacity for the gas gauge.
