Palawan DVT

Palawan DVT represents a complete redesign. The main MCU has changed, and we now use a SoM for the radio.

Palawan Rx ECOs

ECO1: The LED is backwards, and should be flipped around.
ECO2: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA10.
ECO3: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back.
ECO4: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker.
ECO5: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.
ECO6: The board is four layers. This is unnecessary. Make the board two layers.
ECO7: The "Pair" button is not connected to a pin that can do ADC or IRQ. Move "Pair" to PTB7.
ECO8: The LED is not hooked up to a pin that can do PWM. Move LED to PTA12.

ECO1: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper.
ECO2: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA10.
ECO3: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.

Pins:

 PAIR - IRQ, ADC (PTB7 is the only match)
 LED - High-current, PWM (PTA12 is the only match)
 DIO0 - IRQ (PTA10 is closest)