Programming Senoko DVT

From Studio Kousagi Wiki

Revision as of 12:33, 25 April 2014 by Bunnie (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to: navigation, search

clone and build https://github.com/xobs/stm32flash
clone and build https://github.com/xobs/senoko-chibios
- go to ./projects/kosagi-senoko and do a make -j4
while holding down the "reflash" button on senoko, run ./reset.sh to enter STM32 programming mode over UART
from the kosagi-senoko directory, run:

<path-to>/stm32flash/stm32flash -b 115200 -w build/senoko.hex /dev/ttymxc3

then run

 ./reset.sh

To reset the CPU into run mode

Connect to the serial console of the STM32 gas gauge manager:

screen /dev/ttymxc3 115200

from the serial console talking to senoko, run these commands in the "ch>" shell:

ch> chg 1000 12600 3000

The above command powers up the gas gauge so you can program it (powered up via the charger, the battery pack is in safe mode)

ch> gg setup 3 3000

The above command sets 3 cells and 3000mAh as the capacity for the gas gauge.

Retrieved from "https://kosagi.com/w/index.php?title=Programming_Senoko_DVT&oldid=1117"