Difference between revisions of "Palawan DVT"
| Line 3: | Line 3: | ||
==Palawan Rx ECOs== | ==Palawan Rx ECOs== | ||
| − | * | + | * '''ECO1''': The LED is backwards, and should be flipped around. |
| − | * | + | * '''ECO2''': RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. |
| − | * | + | * '''ECO3''': There is a ground (and power) plane directly under the RFM69HW. This should be pulled back. |
| − | * | + | * '''EC04''': The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker. |
| − | * | + | * '''ECO5''': The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer. |
==Palawan Tx ECOs== | ==Palawan Tx ECOs== | ||
| − | * | + | * '''ECO1''': There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper. |
| − | * | + | * '''ECO2''': RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. |
| − | * | + | * '''ECO3''': The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer. |
Revision as of 05:37, 10 June 2017
Palawan DVT represents a complete redesign. The main MCU has changed, and we now use a SoM for the radio.
Palawan Rx ECOs
- ECO1: The LED is backwards, and should be flipped around.
- ECO2: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.
- ECO3: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back.
- EC04: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker.
- ECO5: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.
Palawan Tx ECOs
- ECO1: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper.
- ECO2: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.
- ECO3: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.
