Difference between revisions of "Palawan DVT"
| Line 3: | Line 3: | ||
==Palawan Rx ECOs== | ==Palawan Rx ECOs== | ||
| − | *ECO1*: The LED is backwards, and should be flipped around. | + | * *ECO1*: The LED is backwards, and should be flipped around. |
| − | *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. | + | * *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. |
| − | *ECO3*: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back. | + | * *ECO3*: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back. |
| − | *EC04*: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker. | + | * *EC04*: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker. |
| − | *ECO5*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer. | + | * *ECO5*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer. |
==Palawan Tx ECOs== | ==Palawan Tx ECOs== | ||
| − | *ECO1*: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper. | + | * *ECO1*: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper. |
| − | *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. | + | * *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12. |
| + | * *ECO3*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer. | ||
Revision as of 05:37, 10 June 2017
Palawan DVT represents a complete redesign. The main MCU has changed, and we now use a SoM for the radio.
Palawan Rx ECOs
- *ECO1*: The LED is backwards, and should be flipped around.
- *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.
- *ECO3*: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back.
- *EC04*: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker.
- *ECO5*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.
Palawan Tx ECOs
- *ECO1*: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper.
- *ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.
- *ECO3*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.
