Difference between revisions of "Palawan EVT to DVT changes"
(→Palawan Rx Board changes) |
(→Palawan Tx Board changes) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 25: | Line 25: | ||
To make life easier, add pins for probing GND and VPP. | To make life easier, add pins for probing GND and VPP. | ||
| + | |||
| + | |||
| + | ===ECO6: Change silkscreen for debug pins=== | ||
| + | |||
| + | The J- notation is extremely useless. Use SWx/ADCx notation instead, as it's more useful. | ||
| + | |||
| + | |||
| + | ==Palawan Tx Board changes== | ||
| + | |||
| + | |||
| + | ===ECO7: Decrease white LED resistor R35B to 400 Ohm=== | ||
| + | |||
| + | This LED isn't that bright. Decrease the resistance to around 400 ohm to brighten it up. | ||
| + | |||
| + | |||
| + | ===ECO8: Add more GND headers=== | ||
| + | |||
| + | GND headers are useful. There are only two. Make a lot more. The board can be made thinner by placing the GND headers against one edge, and only using one hole rather than two. | ||
Latest revision as of 06:37, 13 April 2016
Palawan Rx Board changes
ECO1: Swap D11U pins
The diode D11U footprint and schematic pins are swapped. Correct this.
ECO2: Send USB pullups to VPP
The USB pullups on USBDN_RST and USBDP_LED are going to VUSB. They should instead go to VPP, otherwise USB will fail to function.
ECO3: Populate R15U with 1.5k, 10%
Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor.
ECO4: Make debug pins oval
The debug pins on the side should be made oval, for easier soldering
ECO5: Add GND, VPP debug pins
To make life easier, add pins for probing GND and VPP.
ECO6: Change silkscreen for debug pins
The J- notation is extremely useless. Use SWx/ADCx notation instead, as it's more useful.
Palawan Tx Board changes
ECO7: Decrease white LED resistor R35B to 400 Ohm
This LED isn't that bright. Decrease the resistance to around 400 ohm to brighten it up.
ECO8: Add more GND headers
GND headers are useful. There are only two. Make a lot more. The board can be made thinner by placing the GND headers against one edge, and only using one hole rather than two.
