Difference between revisions of "Orchard DVT1 to PVT1 BM"
(Created page with "==ECO1: Save cracked out hippies from accidentally darkwadding themselves== There is a software feature called "ship mode" which is a one-way door on the production doors: on...") |
(→ECO3: Delete BLE) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 21: | Line 21: | ||
| added || SW10B 5x5mm 1.6mm tall PB || | | added || SW10B 5x5mm 1.6mm tall PB || | ||
|} | |} | ||
| + | |||
| + | UPDATE: decided to cancel this ECO. UI changes should make it hard to darkwad yourself. | ||
| + | |||
| + | ==ECO2: Adjust gain on sound== | ||
| + | R11S is adjusted to 47k to make the microphone a little more sensitive. | ||
| + | |||
| + | {| class="wikitable sortable" | ||
| + | |- | ||
| + | ! scope="col" | DVT | ||
| + | ! scope="col" | PVT | ||
| + | ! scope="col" | Notes | ||
| + | |- | ||
| + | | R11S 22k, 1% || R11S 47k, 1%|| | ||
| + | |} | ||
| + | |||
| + | ==ECO3: Delete BLE== | ||
| + | All BLE components removed. | ||
| + | |||
| + | ==ECO4: Flip charge LED== | ||
| + | Put charge status LED on top side so it's visible when case is installed. | ||
Latest revision as of 18:59, 23 June 2015
Contents
ECO1: Save cracked out hippies from accidentally darkwadding themselves
There is a software feature called "ship mode" which is a one-way door on the production doors: once you hit it, the system will power off, and will not power on again until you plug it into a USB port.
I could see this being a problem for some people in the deep playa.
Add a bypass switch + diode to jump-start the board into life again if the battery has a high enough voltage (needs to be about 50% capacity or above to jump-start itself).
This feature is a bad idea in Default because it represents a small, but real, safety risk. You're supposed to isolate the battery entirely from the system during "ship mode" to prevent any accidents. The bypass switch gives the remote possibility that a system can power itself on while shipping, leading to a deep discharge of the battery which is a potentially hazardous condition.
But, safety third!
| DVT | PVT | Notes |
|---|---|---|
| added | D14B BAT54 | any SOD-123 BAT54 variant will do |
| added | SW10B 5x5mm 1.6mm tall PB |
UPDATE: decided to cancel this ECO. UI changes should make it hard to darkwad yourself.
ECO2: Adjust gain on sound
R11S is adjusted to 47k to make the microphone a little more sensitive.
| DVT | PVT | Notes |
|---|---|---|
| R11S 22k, 1% | R11S 47k, 1% |
ECO3: Delete BLE
All BLE components removed.
ECO4: Flip charge LED
Put charge status LED on top side so it's visible when case is installed.
